topic Re: [VIRTUAL CONNECT] Change default gateway in BladeSystem - General

[VIRTUAL CONNECT] Change default gateway

Danilo B — Thu, 17 Jun 2010 12:42:18 GMT

How do I change interconnect bays default gateway on a C-Class Enclosure? I cannot find any place to set default gateway into Virtual Connect Management interface. I tryied to change it using Enclodure Blade IP Addressing on OA but with no success

Thank you all for help

Re: [VIRTUAL CONNECT] Change default gateway

The Brit — Thu, 17 Jun 2010 13:18:52 GMT

Not sure what you mean by VC Management interface. There is an "Enclosure" Management interface which allows communication between the OA's and the Device Bay ILO's and Interconnect Bay Modules. It is not specific to VC. I am not aware of a specific VC management interface.

Anyway, the "Enclosure" management default gateway is set under EBIPA>Device Bays (or Enclosure Bays) tab. You must press "Apply" after making a change.

Also, Device Bays, IC Modules and OA's must be on the same subnet, which means they all use the same default gateway, so they should be set the same.

Hope this helps.

Dave

Re: [VIRTUAL CONNECT] Change default gateway

Danilo B — Thu, 17 Jun 2010 14:05:08 GMT

SOLVED! I had to change default gateway on 'Device Bays' tab and also on 'Interconnect Bays' tab. Previously I changed only on 'Interconnect Bays'

Thank you for help!