https://community.hpe.com/t5/bladesystem-general/pass-thru-module-problem/m-p/4683308#M11361 When I attach Pass-Thru Module to Interconnect bay #5 at c7000, it goes to flashing amber and green mode indicating that there is a port mismatch! <BR /><BR />is it due to using the Chelsio 10G Ethernet Mezzanine?<BR /> Sat, 04 Sep 2010 13:30:04 GMT Nima Gh. 2010-09-04T13:30:04Z https://community.hpe.com/t5/bladesystem-general/pass-thru-module-problem/m-p/4683308#M11361 When I attach Pass-Thru Module to Interconnect bay #5 at c7000, it goes to flashing amber and green mode indicating that there is a port mismatch! <BR /><BR />is it due to using the Chelsio 10G Ethernet Mezzanine?<BR /> Sat, 04 Sep 2010 13:30:04 GMT https://community.hpe.com/t5/bladesystem-general/pass-thru-module-problem/m-p/4683308#M11361 Nima Gh. 2010-09-04T13:30:04Z https://community.hpe.com/t5/bladesystem-general/pass-thru-module-problem/m-p/4683309#M11362 which mezzanine slot have you inserted the ethernet mezzanine card on? If your ethernet pass through module is in interconnect bay 5, then the ethernet mezz card should be in mezz slot 2.<BR /><BR />Please refer to the section "Mapping to interconnect ports" for more information on port mapping in C7000 enclosure. <BR /><BR /><A href="http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00698534/c00698534.pdf" target="_blank">http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00698534/c00698534.pdf</A> <BR /><BR />Regards,<BR />Clarete<BR /> Mon, 06 Sep 2010 05:50:00 GMT https://community.hpe.com/t5/bladesystem-general/pass-thru-module-problem/m-p/4683309#M11362 Clarete Riana 2010-09-06T05:50:00Z https://community.hpe.com/t5/bladesystem-general/pass-thru-module-problem/m-p/4683310#M11363 Yes it is @ Mezzanine Slot 2. I think that our card interface is XAUI while Passthru uses 10GBASE-KR. Sun, 12 Sep 2010 06:42:01 GMT https://community.hpe.com/t5/bladesystem-general/pass-thru-module-problem/m-p/4683310#M11363 Nima Gh. 2010-09-12T06:42:01Z