https://community.hpe.com/t5/bladesystem-general/port-mapping/m-p/4776125#M13296 How do I map more than 2 Ethernet ports to a single ProLiant BL460c server???<BR /><BR />I have 4 1Gb Ethernet Pass-Thru Modules installed. The first two have two connections to each blade. However the two modules installed in 5/6 do not have any ports mapped. Mon, 11 Apr 2011 15:05:58 GMT Clent Kesey 2011-04-11T15:05:58Z https://community.hpe.com/t5/bladesystem-general/port-mapping/m-p/4776125#M13296 How do I map more than 2 Ethernet ports to a single ProLiant BL460c server???<BR /><BR />I have 4 1Gb Ethernet Pass-Thru Modules installed. The first two have two connections to each blade. However the two modules installed in 5/6 do not have any ports mapped. Mon, 11 Apr 2011 15:05:58 GMT https://community.hpe.com/t5/bladesystem-general/port-mapping/m-p/4776125#M13296 Clent Kesey 2011-04-11T15:05:58Z https://community.hpe.com/t5/bladesystem-general/port-mapping/m-p/4776126#M13297 The Port Mapping is Fixed nd we can't map.<BR /><BR />The on-Board Ports will map to Interconnect 1 and 2<BR /><BR />Mezz 1 Ports mapped to inteconnect 3 and 4<BR />Mezz 2 ports mapped to interconnect 5 and 6. If the card in this slot is having 4 ports 2 ports will map to 5 and 6 and remaining 2 map to interconnect 7 and 8.<BR /><BR />So check any Network Mezz card installed in your server. Adjust the Interconnect modules based on the location of that mezz card.<BR /><BR />You can see the port mapping once log into OA. Tue, 12 Apr 2011 00:08:46 GMT https://community.hpe.com/t5/bladesystem-general/port-mapping/m-p/4776126#M13297 Sivaramakrishna_1 2011-04-12T00:08:46Z