topic Adding a FlexFabic LOM blade in BladeSystem - General https://community.hpe.com/t5/bladesystem-general/adding-a-flexfabic-lom-blade/m-p/4792936#M13681 I'm looking for some information regarding what changes, if any, I might need to make to add a BL620c G7 to my existing setup.<BR />The existing setup consists of 2 c7000 chassis with 3 BL860c Integrity blades, 3 BL870c Integrity blades and a BL480c blade. On the backplane I have 4 Cisco MDS 9124e Fabric switches and 4 Cisco CBS 3120X IP switches.<BR /><BR />From the document searching I have found so far all it talks about are the VC-Ethernet modules for the backplane but nothing about working with what I have existing.<BR /><BR />Before executing a PO for the new server I need to find out if my existing infrastructure can handle it. Fri, 27 May 2011 19:27:27 GMT Eric Schimek 2011-05-27T19:27:27Z Adding a FlexFabic LOM blade https://community.hpe.com/t5/bladesystem-general/adding-a-flexfabic-lom-blade/m-p/4792936#M13681 I'm looking for some information regarding what changes, if any, I might need to make to add a BL620c G7 to my existing setup.<BR />The existing setup consists of 2 c7000 chassis with 3 BL860c Integrity blades, 3 BL870c Integrity blades and a BL480c blade. On the backplane I have 4 Cisco MDS 9124e Fabric switches and 4 Cisco CBS 3120X IP switches.<BR /><BR />From the document searching I have found so far all it talks about are the VC-Ethernet modules for the backplane but nothing about working with what I have existing.<BR /><BR />Before executing a PO for the new server I need to find out if my existing infrastructure can handle it. Fri, 27 May 2011 19:27:27 GMT https://community.hpe.com/t5/bladesystem-general/adding-a-flexfabic-lom-blade/m-p/4792936#M13681 Eric Schimek 2011-05-27T19:27:27Z Re: Adding a FlexFabic LOM blade https://community.hpe.com/t5/bladesystem-general/adding-a-flexfabic-lom-blade/m-p/5324979#M17580 I'm assuming that this thread being so old, you already figured this out, but the 3120X is fully supported with G7 blades. You wll just get a pair of 1Gb NICs rather than the 10GB CNAs Wed, 07 Sep 2011 22:15:10 GMT https://community.hpe.com/t5/bladesystem-general/adding-a-flexfabic-lom-blade/m-p/5324979#M17580 Casper42 2011-09-07T22:15:10Z