https://community.hpe.com/t5/bladesystem-general/replacing-a-fc-module/m-p/4798259#M13804 Hope this is not a silly question. :) I am replacing a 4GB FC module in a c7000 (bad port). I assume the swap is transparent since I have two? Will the WWNs or VC profiles be affected? <BR /><BR />Thanks! Mon, 13 Jun 2011 16:28:57 GMT Tuscani_1 2011-06-13T16:28:57Z https://community.hpe.com/t5/bladesystem-general/replacing-a-fc-module/m-p/4798259#M13804 Hope this is not a silly question. :) I am replacing a 4GB FC module in a c7000 (bad port). I assume the swap is transparent since I have two? Will the WWNs or VC profiles be affected? <BR /><BR />Thanks! Mon, 13 Jun 2011 16:28:57 GMT https://community.hpe.com/t5/bladesystem-general/replacing-a-fc-module/m-p/4798259#M13804 Tuscani_1 2011-06-13T16:28:57Z https://community.hpe.com/t5/bladesystem-general/replacing-a-fc-module/m-p/4798260#M13805 No. The only thing that you might have a problem with is F/W levels. If your new module F/W is different to the existing modules, then you will start generating VC errors.<BR />If you have an empty Interconnect bay on your enclosure, put your new module in there and use VCSU to set the F/W version the same as your current modules.<BR /><BR />Dave Mon, 13 Jun 2011 16:50:05 GMT https://community.hpe.com/t5/bladesystem-general/replacing-a-fc-module/m-p/4798260#M13805 The Brit 2011-06-13T16:50:05Z https://community.hpe.com/t5/bladesystem-general/replacing-a-fc-module/m-p/4798261#M13806 Perfect.. thx Dave Mon, 13 Jun 2011 16:56:18 GMT https://community.hpe.com/t5/bladesystem-general/replacing-a-fc-module/m-p/4798261#M13806 Tuscani_1 2011-06-13T16:56:18Z