topic Re: C Class interconnect command line. in BladeSystem - General

C Class interconnect command line.

C Yates — Wed, 17 Oct 2007 05:42:37 GMT

Please can someone help? I'm trying to manually configure an ip address on a 4gb brocade interconnect switch using a serial cable and hyperterminal. I've logged into the OA and connected to the relevant interconnect using the connect interconnect , managed to set the ip address and logged out which leaves me at the interconnect prompt. What is the key sequence to get back to the OA prompt to then connect to the next interconnect? It's driving me mad and I can't find any documentation on it.

Re: C Class interconnect command line.

Raghuarch — Wed, 17 Oct 2007 10:06:15 GMT

Hi Yates,

The character sequence is
Escape character is '_'

It asks you for the
Command: D)isconnect, C)hange settings, send B)reak, E)xit command mode >

Input D it will disconnect the session.

Regards,
Raghuarch

Re: C Class interconnect command line.

C Yates — Wed, 17 Oct 2007 10:16:39 GMT

Thanks for the reply.

Re: C Class interconnect command line.

C Yates — Wed, 17 Oct 2007 10:31:31 GMT

Close thread.