topic P-Class GBe2 Blades in BladeSystem - General

P-Class GBe2 Blades

Alan Strange — Thu, 15 Nov 2007 11:47:53 GMT

Hi,
New to this forum and just wondering two things :-
- how do you break in and do a password recovery on the p-class blade switch.
- can you reset the blade switch back to factory defaults?

Thanks.

Alan.

Re: P-Class GBe2 Blades

Raghuarch — Thu, 15 Nov 2007 14:14:59 GMT

Hi Alan,

Call HP technical support or your service representative to get a backdoor password.
refer to page 60 of the below doc.
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00291270/c00291270.pdf

Regards,
Raghuarch

Re: P-Class GBe2 Blades

RDMOODY — Wed, 28 Nov 2007 07:53:47 GMT

If you'll throw sw1 on the large DIP it will disable the ILo password.

If you throw sw6 and boot to the splash screen and shut down it will reset to factory defaults...

Re: P-Class GBe2 Blades

Víctor Cespón — Wed, 28 Nov 2007 08:05:44 GMT

He's asking about the GbE2 network switch password. He must connect to the serial port on the switch and provide the password that only HP technical supports know.