https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5159002#M15460 You only need 2.1 if you're using flex-10 NICs. If not, you're better off with 1.34. Wed, 25 Feb 2009 12:51:04 GMT Ken Henault 2009-02-25T12:51:04Z https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5158999#M15457 Hi<BR /><BR />I have rack with 4 x C7000's each has 2 VC ETH + 2 VC FC. At the top of the rack I have 2900 (it has 4 10G ports on the back).<BR /><BR />Is there any way for me to daisy chain the 10G ports on the VC ethernet up to the 2900 ? Tue, 24 Feb 2009 04:17:46 GMT https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5158999#M15457 Alex Samad 2009-02-24T04:17:46Z https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5159000#M15458 Enclosure stacking is available as a beta feature in VC 1.34 firmware. It's likely to be released as a fully supported feature later this year. Tue, 24 Feb 2009 16:00:39 GMT https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5159000#M15458 Ken Henault 2009-02-24T16:00:39Z https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5159001#M15459 I was told to have a look at 2.1 Wed, 25 Feb 2009 03:06:51 GMT https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5159001#M15459 Alex Samad 2009-02-25T03:06:51Z https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5159002#M15460 You only need 2.1 if you're using flex-10 NICs. If not, you're better off with 1.34. Wed, 25 Feb 2009 12:51:04 GMT https://community.hpe.com/t5/bladesystem-general/vc-ethernet-cabling/m-p/5159002#M15460 Ken Henault 2009-02-25T12:51:04Z