topic Re: Flex10 - "Management Processor Failed" in BladeSystem - General

Flex10 - "Management Processor Failed"

The Brit — Tue, 28 Dec 2010 12:11:25 GMT

Just grasping at straws. If removing and reseating the module does not resolve this, are there any other suggestions???

Dave.

Re: Flex10 - "Management Processor Failed"

Antonio Milanese — Tue, 28 Dec 2010 12:46:13 GMT

Hi,

Which OA/ILO fw levels?

If you have cli access to OA(s) try to reset ILOs first and then reset OA again and/or force a takeover to secondary one.

Regards,

Antonio

Re: Flex10 - "Management Processor Failed"

The Brit — Tue, 28 Dec 2010 12:53:10 GMT

Thanks for the reply, however the issue is with the Flex10 VC module. OA's are fine.

Re: Flex10 - "Management Processor Failed"

The Brit — Tue, 28 Dec 2010 12:55:20 GMT

Fixed the problem by removing and re-inserting the problem module. Module reboot took about 1 minute, however Domain took about 10 minutes to normalize.

I say this as a "headsup". Logging in is very very slow until the Domain is happy.

Dave.

Re: Flex10 - "Management Processor Failed"

Zygmunt Krawczyk — Tue, 28 Dec 2010 12:57:13 GMT

OA firmware level is important. If you have OA fw level less than 3.21, you need to update it first.