https://community.hpe.com/t5/bladesystem-general/factory-hba/m-p/5960611#M18859 <P>I dont beleive so.&nbsp; It would seem that unless you remove the FC ports from the VC domain, the firmware on the blades will display the VC given WWNs.</P><P>&nbsp;</P><P>-Bob</P> Mon, 11 Feb 2013 19:17:22 GMT Robert_Jewell 2013-02-11T19:17:22Z https://community.hpe.com/t5/bladesystem-general/factory-hba/m-p/5958159#M18853 <P>Is there a way to obtain the Factory WWNs of blades that have been assigned by VC.</P><P>&nbsp;</P><P>We are moving these blades to a Non VirtualConnect chassis and want to pre-stage zoning for that host.</P><P>&nbsp;</P><P>&nbsp;</P> Thu, 07 Feb 2013 20:56:48 GMT https://community.hpe.com/t5/bladesystem-general/factory-hba/m-p/5958159#M18853 BobsYourUncle 2013-02-07T20:56:48Z https://community.hpe.com/t5/bladesystem-general/factory-hba/m-p/5960611#M18859 <P>I dont beleive so.&nbsp; It would seem that unless you remove the FC ports from the VC domain, the firmware on the blades will display the VC given WWNs.</P><P>&nbsp;</P><P>-Bob</P> Mon, 11 Feb 2013 19:17:22 GMT https://community.hpe.com/t5/bladesystem-general/factory-hba/m-p/5960611#M18859 Robert_Jewell 2013-02-11T19:17:22Z https://community.hpe.com/t5/bladesystem-general/factory-hba/m-p/5960639#M18860 <P>I don't recall if the WWN is on sticker attached to the Mezz card itself. During POST you can access the settings of the HBA and see the WWN ID</P><P>&nbsp;</P> Mon, 11 Feb 2013 20:29:46 GMT https://community.hpe.com/t5/bladesystem-general/factory-hba/m-p/5960639#M18860 Jimmy Vance 2013-02-11T20:29:46Z