https://community.hpe.com/t5/bladesystem-general/oa-module/m-p/6737739#M20552 <P>Hi faziz</P><P>&nbsp;</P><P>There is no "right" answer to this although best practice dictates that you should always have the iLO's in a contiguous range (in a management VLAN if you have one) so to ensure that, then you should provide the&nbsp;IP Addresses via the OA then you know what IP Address is assigned to which Bay of the Blade Chassis.</P><P>&nbsp;</P><P>Leonard...</P> Tue, 28 Apr 2015 03:13:55 GMT lholling 2015-04-28T03:13:55Z https://community.hpe.com/t5/bladesystem-general/oa-module/m-p/6731397#M20551 <P>Hi</P><P>&nbsp;</P><P>I want to ask when i connect iLO port in OA Module to exsting cisco switch so that i can access remotely, and i gave OA IP from subnet VLAN 4, should i assign vlan 4 to iLO port from OA GUI, or from cisco switch port ?</P><P>&nbsp;</P><P>&nbsp;</P><P>Thank you</P> Fri, 10 Apr 2015 21:01:43 GMT https://community.hpe.com/t5/bladesystem-general/oa-module/m-p/6731397#M20551 faziz 2015-04-10T21:01:43Z https://community.hpe.com/t5/bladesystem-general/oa-module/m-p/6737739#M20552 <P>Hi faziz</P><P>&nbsp;</P><P>There is no "right" answer to this although best practice dictates that you should always have the iLO's in a contiguous range (in a management VLAN if you have one) so to ensure that, then you should provide the&nbsp;IP Addresses via the OA then you know what IP Address is assigned to which Bay of the Blade Chassis.</P><P>&nbsp;</P><P>Leonard...</P> Tue, 28 Apr 2015 03:13:55 GMT https://community.hpe.com/t5/bladesystem-general/oa-module/m-p/6737739#M20552 lholling 2015-04-28T03:13:55Z