topic New Bladesystem in BladeSystem - General

New Bladesystem

Alhakimi — Thu, 09 Aug 2018 08:43:05 GMT

Hallo dear ,

I got new Bladesystem HPE C7000 with Proliant BL460c Gen10 hosted by provider Datacenter, the Servers should have LUN boot means no Physical HDD in it , so what i got from the provider is WWN and access to the Virtual Connect manager and Onbard administration page.

i am wondering now how i can find those LUNs , map them to my Servers and how i can boot from them

appriciates your kind help

Regards

Rashded

Re: New Bladesystem

Suman_1978 — Fri, 10 Aug 2018 10:48:41 GMT

Hi,

System Admin should be able to configure them for you. Here are some guides which may help you.

SAN Design Reference Guide and Boot from SAN Configuration Guide.

Thank You!
I am an HPE Employee

Was the post useful? Click on the white KUDOS! Thumb below. Kudos is a way of saying thank you to a post.
Useful Links for ProLiant Servers

Re: New Bladesystem

Alhakimi — Sun, 12 Aug 2018 21:13:09 GMT

Thank you for your kind reply , the system Admin was not too helpful , he mentioned that its already configured in the SAN and i need to map it in the Bladesystem now ,, , he just asked me to enable the HBA port in my Bladesystem because the led is showing down , and also i am getting the following error message whenever i try to add new Farbric channel connection :

Fabric

Cause: Condition of fabric Fabric is abnormal

Rootcause: Port enc0:iobay1>x2 is administratively disabled

so i am not sure where do i have to enable it ?

any advise ?

Regards

Rashed

Re: New Bladesystem

Alhakimi — Mon, 13 Aug 2018 17:00:29 GMT

Hi All ,

I got the connection to Fabric C done , there was a connection problem and it was solved after unplug and plug again

Regards

Rashed