Proliant Smart array controller data scrubbing

chuckk281 — Thu, 12 Feb 2015 15:14:21 GMT

VinothKumar was looking for some HP SmartArray controller info:

*************

Hello Team,

I just want to know how frequent the Scrubbing /parity consistency check happened in smart array controller?

If there is a bad sector on the drive which has Unrecoverable Read Error (even with ECC) , my assumption is that the array controller will regenerate the data for the bad block to fulfill the read request.

Please confirm is this assumption is right.

***********

Input from Hiro:

***********

Please see this whitepaper.

I think surface scan will be run after no I/O in 3 seconds by default and you can change it.

HP Smart Array controller technology

http://h20565.www2.hp.com/hpsc/doc/public/display?docId=emr_na-c00687518

P.8

Dynamic sector repair

Disk drive media can develop defects caused by variances in the drive mechanisms under normal operating conditions. To protect data from media defects, HP built a dynamic sector repair feature into Smart Array controllers.

Smart Array controllers perform a background surface analysis during inactive periods, continually scanning all drives for media defects. Smart Array controllers can also detect media defects when accessing a bad sector during busy periods. If a Smart Array controller finds a recoverable media defect, the controller automatically remaps the bad sector to a reserve area on the disk drive. If the controller finds an unrecoverable media defect and you have configured a fault-tolerant logical drive, the controller automatically regenerates the data and writes it to the remapped reserved area on the disk drive.

**********

Comments?

topic Proliant Smart array controller data scrubbing in BladeSystem - General

Proliant Smart array controller data scrubbing