topic Re: Configure ILo2 in a BL460c in BladeSystem - General

Configure ILo2 in a BL460c

Feljav — Tue, 01 Apr 2008 20:12:01 GMT

How can I configure static IP for ilo2 in the Onboard Administrator?

Re: Configure ILo2 in a BL460c

Raghuarch — Tue, 01 Apr 2008 21:25:02 GMT

You can browse to Enclosure Bay IP Addressing Page in the Onboard Administrator. and configure the static IP.

Re: Configure ILo2 in a BL460c

Feljav — Wed, 02 Apr 2008 11:34:17 GMT

I did it, but I received the IP 0.0.0.0

Re: Configure ILo2 in a BL460c

Feljav — Wed, 02 Apr 2008 11:47:08 GMT

I put an IP address in a EBIPA address column and I received the following error:

The page content could not be properly loaded. The following reason was reported:
Could not determine the IP address of the management processor for the requested blade.

Re: Configure ILo2 in a BL460c

Raghuarch — Wed, 02 Apr 2008 13:55:05 GMT

Did you try Reset your OA and check, it works or not.

Re: Configure ILo2 in a BL460c

Feljav — Wed, 02 Apr 2008 14:02:06 GMT

If I do that, I reset the other ilo ip?

Re: Configure ILo2 in a BL460c

Raghuarch — Wed, 02 Apr 2008 14:24:04 GMT

NO It just resets the OA. Not the ILos.

Re: Configure ILo2 in a BL460c

Feljav — Wed, 02 Apr 2008 14:32:31 GMT

But If I do that, it will restore all of my enclosure's settings?

Re: Configure ILo2 in a BL460c

Raghuarch — Wed, 02 Apr 2008 15:09:08 GMT

Reseting the OA through Active OA page doesn't alter Enclosure settings.
If you do a factory Reset then the settings will be affected.

I assume you are having Problem with Only one blade? Correct me if i am wrong.
In the OA syslog Do you see any messages regarding that blade.

Re: Configure ILo2 in a BL460c

Feljav — Wed, 02 Apr 2008 15:17:18 GMT

Yes, the problem is with one blade. I can connect to the other blade ilo.
I don't see any message related with the problem. In the enclosure bay ip addressing, I can't change the ilo's ip for that blade. If I used EBIPA, it give me the ip 192.168.1.21 but I can't connect.

Re: Configure ILo2 in a BL460c

Raghuarch — Wed, 02 Apr 2008 15:44:35 GMT

Can you check the Blades back Pins ... are they damaged?

Re: Configure ILo2 in a BL460c

Feljav — Wed, 02 Apr 2008 16:50:39 GMT

They aren't damages

Re: Configure ILo2 in a BL460c

Raghuarch — Wed, 02 Apr 2008 17:20:43 GMT

I think reset the OA and check it... Some one who had the problem can put more light into this.

Re: Configure ILo2 in a BL460c

Feljav — Wed, 02 Apr 2008 17:49:24 GMT

Where can I do that?

Re: Configure ILo2 in a BL460c

Raghuarch — Wed, 02 Apr 2008 18:45:12 GMT