Blade Installation in same quadrant question

chuckk281 — Thu, 24 Apr 2014 14:26:35 GMT

A blade installation question from Ismail:

**************

One our customer would like to install 2x BL460c Gen 8 (half height) and 1 x BL660c (full height) Gen8 beside each other. He would like to install BL460x Gen8 in bay 5 & 13 and the BL660c Gen8 in bay 6. As far as I know there is no way to install them beside each other. Could you please if this setup is supported by any documents?

**************

Input from Cullen:

************

You can’t mix 2 BL460s and one BL660 in the same quadrant. The reason is one of physical support – the half-height blade in the top slot will put a strain on the midplane connectors and could fall out if the bottom blade is removed. That could damage both the server and the midplane. The only way to mix 2 half-height blades with a full-height blade in a quadrant is to have an expansion blade in the bottom slot with a support bracket attached to support the blade above.

Both the C7000 QuickSpecs and the user guide describe this.

**************

And info from Kim:

***************

Not supported

The c7000 enclosure is divided into four zones or quadrants by the vertical support metalwork. Within each zone, a removable divider is used to support half-height devices. To install a full-height blade in any zone, this divider must be removed. As a consequence, a zone can only contain either full-height server blades or half-height server blades.

http://h20565.www2.hp.com/portal/site/hpsc/template.PAGE/public/kb/docDisplay?javax.portlet.begCacheTok=com.vignette.cachetoken&javax.portlet.endCacheTok=com.vignette.cachetoken&javax.portlet.prp_ba847bafb2a2d782fcbb0710b053ce01=wsrp-navigationalState%3DdocId%253Demr_na-c01039151-8%257CdocLocale%253D%257CcalledBy%253D&javax.portlet.tpst=ba847bafb2a2d782fcbb0710b053ce01&ac.admitted=1398234323152.876444892.492883150

****************

Comments?

topic Blade Installation in same quadrant question in BladeSystem - General

Blade Installation in same quadrant question