https://community.hpe.com/t5/bladesystem-general/ilo-network/m-p/5799569#M27952 any idea? Mon, 10 Sep 2012 18:10:19 GMT eduzav 2012-09-10T18:10:19Z https://community.hpe.com/t5/bladesystem-general/ilo-network/m-p/5796265#M27951 <P>My datacenter provider has one c7000 with ebipa addressing on theirs bays.</P><P>I buy 2 half blade for install on datacenter and I need know if I can request Datecenter to change the addressing of my two blades to static network different than EBIPA addresing and the idea is can administer the two ILOs of my blade servers without affect c7000 network environment.</P><P>&nbsp;</P><P>I attached a similar show config enclosure configuration</P><P>&nbsp;</P><P>The devices of enclosure are:</P><P>&nbsp;</P><P>Enclosure<BR />SHOW INTERCONNECT INFO ALL o Interconnect Bay Power Summary:<BR />1 HP 1/10Gb VC-Enet Module<BR />2 HP 1/10Gb VC-Enet Module<BR />3 Brocade 4/24 SAN Switch for HP<BR />SHOW OA INFO<BR />Onboard Administrator #1 Firmware Ver. : 3.30<BR />Onboard Administrator #2 Firmware Ver. : 3.30</P><P>&nbsp;</P><P>&nbsp;</P><P>Is it possible?</P><P>if ebipa has 192.168.30.x/24 addressing I need which my ilo are on 172.16.x.x/16 network and then I connect that network on virtual machine of one blade for only admin proposes.</P><P>&nbsp;</P><P>Thanks a lot.</P><P>&nbsp;</P><P>&nbsp;</P> Fri, 07 Sep 2012 00:58:30 GMT https://community.hpe.com/t5/bladesystem-general/ilo-network/m-p/5796265#M27951 eduzav 2012-09-07T00:58:30Z https://community.hpe.com/t5/bladesystem-general/ilo-network/m-p/5799569#M27952 any idea? Mon, 10 Sep 2012 18:10:19 GMT https://community.hpe.com/t5/bladesystem-general/ilo-network/m-p/5799569#M27952 eduzav 2012-09-10T18:10:19Z