Can't connect to VC

xsadmin — Fri, 09 Feb 2018 11:36:27 GMT

Hello,

I bought two VC 10/10D refurbished modules. Put them into 1 and 2 bays. When I try to connect to 1 bay module - I have a wizard. But when I trying to connect to 2 bay - I have "The active Virtual Connect Manager is not at this IP address currently. We will continue to check every 30 seconds. If you expect the active Virtual Connect Manager at this IP address, please wait."

When I tried to connect throught console I get "Virtual Connect Manager not found at this IP address. The location of Virtual Connect Manager has not yet been established, please wait for initialization to complete."

When I tried to connect throught ssh I get "Virtual Connect Manager not found at this IP address. The location of Virtual Connect Manager has not yet been established, please wait for initialization to complete."

I tried move them to another bays but it didn't helped.

Can anybody help me?

Re: Can't connect to VC

peyrache — Fri, 09 Feb 2018 11:39:27 GMT

Why did you not run wizard on module 1 ?

Re: Can't connect to VC

Torsten. — Fri, 09 Feb 2018 11:42:10 GMT

The virtual connect manager as your interface to the modules is running on the master module only, hence you can access it only using one module, the master. But configuration is mde for both modules from there.

topic Can't connect to VC in BladeSystem - General

Can't connect to VC

Re: Can't connect to VC

Re: Can't connect to VC