How to re-enable a stacking link

Kerry Quillen — Thu, 23 Aug 2018 17:36:02 GMT

Up until a few weeks ago, we were using VC port x8 to connect to an iscsi network, leaving x7 as our stacking link ports. We have 10 c7000 enclosures. We've stopped using the iscsi network so, on each c7000, I deleted all iscsi networks and pulled the sfp's from the x8 ports. AFter a few minutes, x8 returned to serving as stacking links. However, one c7000 only shows its stacking link using x8. So apparenly x7 was never participating. I never saw any stacking link warnings prior to removing the sfp's so it was never noticed. So my question is, is there a way to re-enable x7 so it will act as a stacking link port again?

Re: How to re-enable a stacking link

frenchy94 — Thu, 23 Aug 2018 18:41:47 GMT

What is VC module ? what is version used ?

---
L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
https://www.avast.com/antivirus

topic How to re-enable a stacking link in BladeSystem - General

How to re-enable a stacking link

Re: How to re-enable a stacking link