topic Re: VIrtual connect flex-10/10d configuration issue in BladeSystem - General

VIrtual connect flex-10/10d configuration issue

Andrew_R — Wed, 29 Apr 2020 14:46:55 GMT

Good afternoon all.

I have inherrited a Uat environement which consists of several BL460C GEN 8 Blades connecting through FLEX10-10D modules.

Ther person who configured only enabled 1 ofd the flex nics on all the servers.

How do I enable the remaining flexnics without having to recreate profiles from scratch and which setting do I need to change?

Thanks for the help

Andrew

Re: VIrtual connect flex-10/10d configuration issue

frenchy94 — Wed, 29 Apr 2020 14:52:21 GMT

Hi

Just edit profile and add port in configuration

--
L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
https://www.avast.com/antivirus

Re: VIrtual connect flex-10/10d configuration issue

Kashyap02 — Fri, 01 May 2020 06:05:38 GMT

@Andrew

Can you share the below details of the

Flex Nic model?

Where can see that only one port is enabled?

can you share a screenshot ?

Re: VIrtual connect flex-10/10d configuration issue

Kashyap02 — Tue, 05 May 2020 03:08:32 GMT

@Andrew_R

Share the above requested details.

Re: VIrtual connect flex-10/10d configuration issue

Andrew_R — Sun, 17 May 2020 16:37:51 GMT

Hi @Kashyap02

There are currentlly only 2 uplinks available and vmware is only seeing 2 vmnics.

For some unknown reason the first uplink is showing as active with the remaining 3 passive. How do I make the 2nd uplink active?

I would also like to know what I would need to do to enable a seperate uplink on each vc uplink for iscsi traffic. It will be used purelly for the iscsi vlan. Is there any specific settings I need to have configured on the cisco 3750 switch which these new uplinks will be patched into?

Also is there any way to clone the uplink config if the person who set it up did it incorrectlly by using the internal stacking port for external uplinks?