topic Re: VC Flex-10/10D Module FW update in BladeSystem - General

VC Flex-10/10D Module FW update

meekrob — Wed, 10 May 2017 09:51:07 GMT

Hi All,

im sending this message requesting some help/guidance if possible, im trying to update firmware for VC flex-10/10D module and getting somme errors related to ssh session that couldnt be established when trying via hpsum and even when trying via vcsu "[VcsuSftp.cpp:88] : SSH connection could not be established" eventhough i can connect via ssh-> putty ( ip address of the interconnect module in bay1) to the vcm without any issue

Kindly note that current firmware version is 3.7 and im trying to update 1st to 4.01

Also note that OA and ilo update were OK but still facing issues with VC ;( WEIRD

Any suggestion is much appreciated

Regards

Re: VC Flex-10/10D Module FW update

msh_it — Thu, 18 May 2017 06:25:59 GMT

Hello

Did you try to update it by connecting a laptop directly to the OA?

Re: VC Flex-10/10D Module FW update

meekrob — Tue, 23 May 2017 14:50:01 GMT

Hello and thanks for your reply,

eventhough with direct connection, still getting errors (related to authentication) when upgrading:

[Tue May 23 15:37:10 2017] (71004)[VcsuCore.cpp:1029] : Domain configuration is present
[Tue May 23 15:37:10 2017] (71004)[VcsuCore.cpp:1043] : This is primary enclosure
[Tue May 23 15:37:10 2017] (71004)[VcsuInit.cpp:811] : VCM user authenticated successfully
[Tue May 23 15:37:10 2017] (71004)[VcmWrap.cpp:1732] : VCM Firmware Version: 3.70
[Tue May 23 15:39:11 2017] (71004)[VcsuCore.cpp:3841] : Unknown error detecting Virtual Connect Domain Mode
[Tue May 23 15:39:11 2017] (71004)[VcsuCore.cpp:3842] : Return code was 74 for bay 1
[Tue May 23 15:41:11 2017] (71004)[VcsuCore.cpp:3841] : Unknown error detecting Virtual Connect Domain Mode
[Tue May 23 15:41:11 2017] (71004)[VcsuCore.cpp:3842] : Return code was 1 for bay 2
[Tue May 23 15:41:11 2017] (71004)[VcsuInit.cpp:869] : Error collecting Domain Info
[Tue May 23 15:41:11 2017] (71004)[AuthenticateTarget.cpp:106] : authenticateVCM failed
[Tue May 23 15:41:11 2017] (71004)[AuthenticateUser.cpp:56] : Authentication failed
[Tue May 23 15:41:14 2017] (71004)[OaWrap.cpp:793] : User successfully deleted

Regards

Re: VC Flex-10/10D Module FW update

msh_it — Sun, 28 May 2017 04:51:53 GMT

Hello

Try to reset the VCM, so if the primary module is bay 1, move it to bay 2, also if possible reset both modules and reset the OA, then try again.