https://community.hpe.com/t5/bladesystem-general/factory-default-wwn/m-p/6633876#M30284 <P>I'm trying to move some blades from an enclosure using the VC-assigned FC WWN's to a different enclosure that is set to use the factory-default ones.&nbsp; I'd like to be able to pre-provision my zone changes and host ports in the array, but I haven't been able to find out what the factory-default WWN's are.</P><P>&nbsp;</P><P>Every place I look shows only the VC assigned ones.</P><P>&nbsp;</P><P>Is there a way to see the factory-default WWN's without shutting down the server?</P><P>&nbsp;</P><P>Thanks in advance for any suggestions.</P> Mon, 29 Sep 2014 19:44:17 GMT LARRY FUTCH 2014-09-29T19:44:17Z https://community.hpe.com/t5/bladesystem-general/factory-default-wwn/m-p/6633876#M30284 <P>I'm trying to move some blades from an enclosure using the VC-assigned FC WWN's to a different enclosure that is set to use the factory-default ones.&nbsp; I'd like to be able to pre-provision my zone changes and host ports in the array, but I haven't been able to find out what the factory-default WWN's are.</P><P>&nbsp;</P><P>Every place I look shows only the VC assigned ones.</P><P>&nbsp;</P><P>Is there a way to see the factory-default WWN's without shutting down the server?</P><P>&nbsp;</P><P>Thanks in advance for any suggestions.</P> Mon, 29 Sep 2014 19:44:17 GMT https://community.hpe.com/t5/bladesystem-general/factory-default-wwn/m-p/6633876#M30284 LARRY FUTCH 2014-09-29T19:44:17Z https://community.hpe.com/t5/bladesystem-general/factory-default-wwn/m-p/6650334#M30285 <P>If you will check the system information using Onboard Administrator it will show the factory coded WWN.</P><P>&nbsp;</P><P>If you are going to connect blade server in a chassis which dont have VC configured or set to Factory WWN, system information in OA will show factory WWN.</P> Sun, 19 Oct 2014 17:44:52 GMT https://community.hpe.com/t5/bladesystem-general/factory-default-wwn/m-p/6650334#M30285 rkjha_hp 2014-10-19T17:44:52Z