topic Re: the virtual connection flex-10 interconnection configuration change in BladeSystem - General

the virtual connection flex-10 interconnection configuration change

singvey — Thu, 11 Dec 2014 01:41:25 GMT

we have two hp c7k blade systems. when we removed the vc flex-10 interconnect modules from the c7k chassis, we forgot to mark which c7k chassis they were removed from. what will happen if we install the vc flex-10 interconnect modules into the wrong c7k chassis?

1-each chassis will maintain its original vc configuration

2- the configuration of the vc on the chassis will be swapped

3- both chassis will default to factory default settings.

4-POST will issue a warning that the wrong vc modules are inserted .

P.S. This thread has been moved from HP BladeSystem > Virtualization to HP BladeSystem Virtual Connect. - Hp Forum Moderator

Re: the virtual connection flex-10 interconnection configuration change

Psychonaut — Tue, 03 Sep 2013 15:43:05 GMT

Assuming that the domain is only these two VC's (and that the chassis are not stacked); #2 is what should happen.

Re: the virtual connection flex-10 interconnection configuration change

Server-Support — Wed, 10 Dec 2014 04:10:40 GMT

So how did you finally end up with the solution or the situation ?

please share it here :-)