topic Re: How to Reset Administrator Password (If You Don't Have Factory Default) in BladeSystem - General

How to Reset Administrator Password (If You Don't Have Factory Default)

justdan96 — Wed, 11 Apr 2012 10:56:58 GMT

This is more a hypothetical question but I could easily see this as a real-world scenario in some places:

If you have lost the administrator password to a Virtual Connect most guides say to do a factory reset. The factory default password is written on a label. However what if the label has been ripped off (maybe someone thought it would be easier to configure it at their desk and they forgot to re-attach the label)?

Is there any way to either set the administrator password to a known value, pre-calculate the factory default password or otherwise be able to get administrator access? I would guess that the HP support dump has the password value and they might be able to tell you what that is if you can prove you are the system owner but I just wondered if anyone has ever run into this kind of issue?

Thanks,

-Dan

Re: How to Reset Administrator Password (If You Don't Have Factory Default)

Psychonaut — Thu, 12 Apr 2012 15:10:29 GMT

The information is also on a tag on the top of the module, just pull the module.

Re: How to Reset Administrator Password (If You Don't Have Factory Default)

Hongjun Ma — Sun, 15 Apr 2012 05:02:08 GMT

there is a way to recover default password even without any label,

please take a look at VC setup and installation guide

http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01732252/c01732252.pdf

page 115

Resetting the Administrator password and DNS settings

Re: How to Reset Administrator Password (If You Don't Have Factory Default)

jlackman — Tue, 28 Apr 2015 14:41:46 GMT

I don't know if they updated the document, but it's page 117 now, thanks.