VC Flex-10 Question on cable types.

chuckk281 — Wed, 30 Apr 2014 18:38:04 GMT

Kamlesh had a VC cable interface question:

***************

We are installing a X9730 (Ibrix) which has a C7000 and on the VC Flex-10 the X1 Port is set to CX4 port we want to change this to X1 on the SFP+. Question is how do we change it?? I have press the arrow as shown with the red circle in the picture below without any joy.

Any help would be appreciated.

***********

Reply from Denis:

***************

The X1 port will move to the SFP during the install process, it just defaults to the CX4 when unconfigured.

***************

And from Dan:

**************

Just Plug in the SFP+ transceiver in the X1 slot and the CX4 will be superseded automatically.

X7 and X8 are the same. Put a Transceiver in one of those slots and the corresponding internal Cross Connect through the midplane will be automatically disabled.

**************

Comments?

topic VC Flex-10 Question on cable types. in BladeSystem - General

VC Flex-10 Question on cable types.