topic Re: After upgrade to 3.60 VC domain cannot finish synchronization in BladeSystem - General

After upgrade to 3.60 VC domain cannot finish synchronization

vmwaremine — Wed, 27 Mar 2013 11:34:24 GMT

Hi all

I did upgrade of VC to version 3.6 on C7000 and after upgrade VC domain synchronizing forever, see printscreen,

OA - 3.71

VC - 3.60

What I did:

Enclosure details:

C7000 - single enclosure

VC Flex 10 - two modules

HP 4Gb VC_FC module - 2 modules

HP 1/10 VC-Enet module

At the moment VC is not operational, sometimes even log in is not possible.

Any advice ?

Thanks

Artur

hanky_q — Wed, 27 Mar 2013 11:40:18 GMT

Can you connect to the secondary VC Module?

vmwaremine — Wed, 27 Mar 2013 12:27:05 GMT

yes, I can connect to secondary module but situation is the same

Artur

hanky_q — Wed, 27 Mar 2013 13:05:27 GMT

Have you reboot the seconday Module? Maybe that device could not load the configuration

vmwaremine — Wed, 27 Mar 2013 13:09:09 GMT

Yes, I did reboot and power off both devices + 1/10 ENET module

Artur

hanky_q — Wed, 27 Mar 2013 20:10:25 GMT

What happen if you disconect the seconday VC from the network?

Maybe both modules are trying to get primary.

And are both with the same Version?

Jongo — Fri, 13 Sep 2013 14:39:51 GMT

Maybe if you have a Virtual IP address to access VC has got out of sync.

Disable it and re-enable via an ssh session to one of he bays