topic Re: VC Ethernet module failover in BladeSystem - General

VC Ethernet module failover

Thomas Duncan (HSA) — Tue, 17 Jun 2008 23:49:29 GMT

Is there a specific sequence to replace a primary VC-Enet module that has failed? (Like the OA where you pull the secondary module and install it in the primary bay and then install the new unit in the redundant bay).
I’ve spent a little time in the user guide, but not found the scenario.

Re: VC Ethernet module failover

JKytsi — Wed, 18 Jun 2008 06:35:44 GMT

So your primary one has failed ? The secondary VC module takes it's place and when you insert a new one to bay1 it will sync the data and you can do a manual failover back to bay1 from VC manager tools.

Re: VC Ethernet module failover

Thomas Duncan (HSA) — Wed, 18 Jun 2008 16:54:51 GMT

Thank you.