https://community.hpe.com/t5/bladesystem-general/link-state-without-smartlink-on-active-passive/m-p/5382679#M32823 <P>Hi there,</P><P>&nbsp;</P><P>This is for situations where the driver does not support DCC (ex,: Linux):</P><P>&nbsp;</P><P>- If I have an active-passive setup (VC1 active, VC2 passive) and don't enable smartlink, will the FlexNics go down when both uplinks are down?</P><P>- Also, if I use the crossconnect for some VNETs, will the FlexNics go down when both uplinks go down (without support for DCC in the driver)?</P><P>&nbsp;</P><P>Regards.</P> Sat, 05 Nov 2011 20:50:32 GMT ricdanger21 2011-11-05T20:50:32Z https://community.hpe.com/t5/bladesystem-general/link-state-without-smartlink-on-active-passive/m-p/5382679#M32823 <P>Hi there,</P><P>&nbsp;</P><P>This is for situations where the driver does not support DCC (ex,: Linux):</P><P>&nbsp;</P><P>- If I have an active-passive setup (VC1 active, VC2 passive) and don't enable smartlink, will the FlexNics go down when both uplinks are down?</P><P>- Also, if I use the crossconnect for some VNETs, will the FlexNics go down when both uplinks go down (without support for DCC in the driver)?</P><P>&nbsp;</P><P>Regards.</P> Sat, 05 Nov 2011 20:50:32 GMT https://community.hpe.com/t5/bladesystem-general/link-state-without-smartlink-on-active-passive/m-p/5382679#M32823 ricdanger21 2011-11-05T20:50:32Z