Virtual Connect configuration clone

chuckk281 — Wed, 20 Apr 2011 19:26:05 GMT

Andy had a Virtual Connect fail-over question from a customer:

****************

I have a customer that has a 7000 enclosure with only one VC flex 10 installed and he is ready to add the second one in bay 2 but it was configured before and removed. They have made domain config changes since then and are on the same firmware version. I’m trying to confirm that the active/surviving VC domain config will clone to the VC unit being added?

Thanks in advance,

********************

Mark replied:

***********************

The VC Domain configuration that is currently stored in Flash on VC Flex-10 in Bay 1 will be replicated to the VC Flex-10 in Bay 2 when it is installed since it will be automatically integrated into the current Active/running VC Domain.

Any configuration parameters be will pushed to the VC module in Bay 2 such as “SNMP Settings”, MAC Cache Failover, networks, etc. If it is necessary that a CLI-Reset be issued to Bay 2 before that configuration is set, VC Domain that is running on Bay 1 will take care of that.

I would always suggest doing a Backup of the VC Configuration before installing any new modules.

************

Any other comments for Andy?

topic Virtual Connect configuration clone in BladeSystem - General

Virtual Connect configuration clone