How to force reset of Virtual Connect Flex-10 module?

chuckk281 — Thu, 10 Jun 2010 16:16:57 GMT

Robert wanted to reset the VC Flex-10 modules for a customer:

**********************************************************************************************

Question: How do you reset the configuration of a Flex-10 module if you cannot access it from the GUI or SSH?

***********************************************************************************************

Lee jumped into the problem:

***************************************************************************************

Team,

I asked the customer the remove both modules and only replace the bay 1 module until the VCM comes up, then plug in the bay 2 module. I’ve never tried it, but I’ll assume it works that way.

The real question is this: What if the customer can’t remove the modules in a situation like this, i.e. no DC access. Is there a way to force the module in bay 1 to take over Primary? Is there some undocumented feature that can force a module to be primary if both are showing secondary?

****************************************************************************************

Greg got involved:

*****************************************************************************

Via the OA you can either poweroff or reset any interconnect or device bay

Affecting this on VC2 would force the VC1 to become primary.

Note: You need to be VERY confident that the hosted OS loads are well connected as far as network paths are concerned, ie. teamed via both VC1 and VC2

*******************************************************************************

To which Cullen remarked:

*************************************************************************

Based on my experience, it can take quite a long time (more than 15 minutes) for a module to become VCM primary when you power down the other module.

*******************************************************************

Any other input here? Let us know.

topic How to force reset of Virtual Connect Flex-10 module? in BladeSystem - General

How to force reset of Virtual Connect Flex-10 module?