Checking out a problem in the lab using Virtual Connect Flex-10

chuckk281 — Wed, 23 Jun 2010 20:04:38 GMT

Yan was looking for some help when looking at a VC Flex-10 issue.

**********************************************************************************

Our customer application environment was BL460CG6+VCFlex10+Vsphere4.1(topology as attached),but there were some problems during the implement.

They use 2 VC flex-10 in C7000 with firmware 2.33 ,and smartlink and vlan tunneling was assigned. NIC driver version was bnx2x1.52 on Vsphere4.1; 2 VC module uplink to Cisco catalyst 3750G and Catalyst 4948 as the attachment.

Current issue is warning on switch, detail warning information as below:

May 27 14:28:55: %SW_MATM-4-MACFLAP_NOTIF: Host 0050.567e.cd76 in vlan 10 is flapping between port Po1 and port Po3

May 27 14:28:55: %SW_MATM-4-MACFLAP_NOTIF: Host 0050.5671.d3a0 in vlan 10 is flapping between port Po1 and port Po3

May 27 14:28:55: %C4K_EBM-4-HOSTFLAPPING: Host 00:50:56:7E:CD:76 in vlan 10 is flapping between port Po3 and port Po1

May 27 14:28:55: %C4K_EBM-4-HOSTFLAPPING: Host 00:50:56:71:D3:A0 in vlan 10 is flapping between port Po3 and port Po1

Another issue: every physical NIC on 460G6 was split to 3 logical NIC, after perform smart link，the Vmware NIC can’t detect the uplink interrupt .so the using NIC model was Beacon Probing ，but the customer felt net speed slowly . It seemed DCC unavailable.

Your kind feedback is appreciated.

******************************************************************************************

Carlos jumped in:

*********************************************************************************

Yan,

In regards to your error:

May 27 14:28:55: %SW_MATM-4-MACFLAP_NOTIF: Host 0050.567e.cd76 in vlan 10 is flapping between port Po1 and port Po3

May 27 14:28:55: %SW_MATM-4-MACFLAP_NOTIF: Host 0050.5671.d3a0 in vlan 10 is flapping between port Po1 and port Po3

May 27 14:28:55: %C4K_EBM-4-HOSTFLAPPING: Host 00:50:56:7E:CD:76 in vlan 10 is flapping between port Po3 and port Po1

May 27 14:28:55: %C4K_EBM-4-HOSTFLAPPING: Host 00:50:56:71:D3:A0 in vlan 10 is flapping between port Po3 and port Po1

This is due to a teaming fail over. When the team fails to the secondary NIC the team MAC is learned on the second switch.Channel-group-3 and Channel-group-1. That is the reason for the flapping. Check the team status to see as to the reason why they are failing over.

************************************************************************

Any other comments or suggestions? Let us know if you have seen this problem and how you resolved it.

topic Checking out a problem in the lab using Virtual Connect Flex-10 in BladeSystem - General

Checking out a problem in the lab using Virtual Connect Flex-10