https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/299#M33575 You are way too good man!! I should have you work on my knee. Fri, 24 Apr 2009 18:50:00 GMT chuckk281 2009-04-24T18:50:00Z https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/297#M33573 I was putting some new processors in a new "Beta" version of a blade here and then powered it up to see if everythign was working. Well, not all was well and after trying some things, I found out that the processor socket magically had some bent pins. I carefully unbent the pins and after re-assembling it, everything worked fine. Now, I can't say that I had the most unique and technically savvy way of unbending those pins. Does a sharp point on a pencil sound technical? Anyway, I was wondering if this group has something that I should have in my toolbox and is more technically sound. Help a poor software guy, please!! Fri, 24 Apr 2009 18:13:00 GMT https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/297#M33573 chuckk281 2009-04-24T18:13:00Z https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/298#M33574 Whatever works! I have found it's best to use a microscope on a workbench and one of those dentist's probe tools. (from one software guy to another) Fri, 24 Apr 2009 18:40:00 GMT https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/298#M33574 John Cagle 2009-04-24T18:40:00Z https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/299#M33575 You are way too good man!! I should have you work on my knee. Fri, 24 Apr 2009 18:50:00 GMT https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/299#M33575 chuckk281 2009-04-24T18:50:00Z https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/300#M33576 Only BTO has this problem - Buy via CTO and you should not have this issue ( Though CTO is bit expensive than BTO but is worth the price ) - Consider this CTO option if you are buying lot of equipment - Replace the motherboard instead of using tools fixing it. Hope this helps. Sat, 25 Apr 2009 22:15:00 GMT https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/300#M33576 vcblades 2009-04-25T22:15:00Z https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/301#M33577 I have found the best tool for straightening bent pins is one of those mechanical 'propeller' pencils (without the lead, obviously). The tube formed by the tip is a good size for sliding over the bent pin and moving it back into shape/position. R. Sat, 25 Apr 2009 22:39:00 GMT https://community.hpe.com/t5/bladesystem-general/bent-processor-pins-and-suggestions/m-p/301#M33577 Robin Geddes 2009-04-25T22:39:00Z