https://community.hpe.com/t5/bladesystem-general/vc-enet-status/m-p/597#M33723 check the mezz screws on the back side of the cabinet, make sure they are tightened down. The mexzz blade gets loose over time from installing and removing blades and can cause this type of error, and all red x's in sim. Tue, 29 Sep 2009 21:39:00 GMT johnschaves 2009-09-29T21:39:00Z https://community.hpe.com/t5/bladesystem-general/vc-enet-status/m-p/596#M33722 Hi All, Does anyone know what would cause these errors and any fix? We lost the blades connectivity and it was re-gained after a while. OA : 2.20 VC-ENET : 2.21 OA: Health status of interconnect in bay 6 changed to Unknown OA: Health status of interconnect in bay 2 changed to Unknown OA: Health status of interconnect in bay 5 changed to Unknown OA: Health status of interconnect in bay 2 changed to OK OA: Health status of interconnect in bay 2 changed to Unknown OA: Health status of interconnect in bay 6 changed to OK OA: Health status of interconnect in bay 6 changed to Unknown OA: Health status of interconnect in bay 5 changed to OK OA: Health status of interconnect in bay 5 changed to Unknown Thanks in advance. [Updated on 9/22/2009 8:49 PM] Wed, 23 Sep 2009 02:52:00 GMT https://community.hpe.com/t5/bladesystem-general/vc-enet-status/m-p/596#M33722 Sameer_Nirmal 2009-09-23T02:52:00Z https://community.hpe.com/t5/bladesystem-general/vc-enet-status/m-p/597#M33723 check the mezz screws on the back side of the cabinet, make sure they are tightened down. The mexzz blade gets loose over time from installing and removing blades and can cause this type of error, and all red x's in sim. Tue, 29 Sep 2009 21:39:00 GMT https://community.hpe.com/t5/bladesystem-general/vc-enet-status/m-p/597#M33723 johnschaves 2009-09-29T21:39:00Z