topic Re: Not Able to access OA in BladeSystem - General

Not Able to access OA

Sunil_Rawat — Mon, 05 May 2025 23:33:03 GMT

HP Gen BL 460 +10 c7000 OA display + 11/16 while initialize

OA1= Not Ping

OA2= Not Ping

Initially OA2 is accesseable and try to Make OA2 as Primary. Takeover Initialize, After 180 Minute, its Success, then Reload but after that OA2 is also not accessable.

OA2= Login in Standalone Mode

In General while initializing OA it shows 11/16 in Display Panel.

How to resolve the Issue. How we can access OA?

Re: Not Able to access OA

TVVJ — Wed, 30 Apr 2025 10:08:57 GMT

Hello,

Check the IP addressing for the OA modules and see if it helps.

Regards,

Re: Not Able to access OA

Rama2 — Mon, 05 May 2025 02:17:45 GMT

Issue:
Both OA modules are not working; SID is stuck at 11/16 during initialization.

Solution Steps (Hardware Isolation):

Remove all blades from the enclosure.
Reset both OA modules.
Allow the OA to fully boot and check if it is accessible.
If the OA becomes reachable, insert one blade at a time.
Allow each blade to complete Virtual Connect (VC) configuration.
After inserting each blade, check if OA connectivity remains stable.
If OA becomes unresponsive after inserting a specific blade, remove that blade and reset the OA again.
Reinsert the problematic blade without mezzanine cards.
If OA remains stable, insert mezzanine cards one by one and monitor after each.
If the issue still occurs without mezzanine cards, the system board of the blade may be faulty.

If issue still persist, raise a support ticket with HPE.

Query: Not Able to access OA

support_s — Tue, 06 May 2025 06:15:06 GMT

Hello,

Let us know if you were able to resolve the issue.

If you are satisfied with the answers then kindly click the "Accept As Solution" button for the most helpful response so that it is beneficial to all community members.

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".