https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338991#M4877 No other way than pulling the plug =) Fri, 16 Jan 2009 07:46:42 GMT JKytsi 2009-01-16T07:46:42Z https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338990#M4876 I checked into the C7000. I don't see any power switches, therefore if I do need to power down the C7000, should I just unplug the power cords?<BR /><BR />In addition, the "device power sequence" shown on the OA, is it ONLY used for determining the powerup sequence, and my blades do not have any dependency, I can just leave them disabled and will the blades be automatically come up after the C7000 has been up?<BR /><BR />thanks Fri, 16 Jan 2009 07:36:36 GMT https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338990#M4876 Anna Cheng 2009-01-16T07:36:36Z https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338991#M4877 No other way than pulling the plug =) Fri, 16 Jan 2009 07:46:42 GMT https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338991#M4877 JKytsi 2009-01-16T07:46:42Z https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338992#M4878 thanks.<BR />Easy answer :-).<BR /><BR />But does any know whether I need to "enable" the device power sequence? I know I can use that to order to power up sequence, but if I just want everything to come up, do I need to do anything?<BR /><BR /> Sat, 17 Jan 2009 08:45:09 GMT https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338992#M4878 Anna Cheng 2009-01-17T08:45:09Z https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338993#M4879 nope =) Sat, 17 Jan 2009 12:49:42 GMT https://community.hpe.com/t5/bladesystem-general/power-down-procedure-for-c7000/m-p/4338993#M4879 JKytsi 2009-01-17T12:49:42Z