topic Re: adding blade in enclosure gives an error in BladeSystem - General

adding blade in enclosure gives an error

Shrinivas C. Kulkarni — Mon, 16 Feb 2009 05:24:30 GMT

Server Blade Enclosure Inadequate Power To Power On: Lost Redundant Power (Enclosure Address 0000, Slot 7)

power configration -ac redundant
dynamic power mode enable

Re: adding blade in enclosure gives an error

JKytsi — Mon, 16 Feb 2009 12:59:21 GMT

Update ILO Fws and then OA

Re: adding blade in enclosure gives an error

Ken Henault — Mon, 16 Feb 2009 14:01:03 GMT

This is probably a p-Class. Check that the enclosure power management firmware is up to date.

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=1121598&prodNameId=3288176&swEnvOID=1005&swLang=8&mode=2&taskId=135&swItem=MTX-9e0e8e80b2d545eeaa26c38678

Re: adding blade in enclosure gives an error

Shrinivas C. Kulkarni — Tue, 17 Feb 2009 03:55:10 GMT

chk my attachment

Re: adding blade in enclosure gives an error

Timur S Lukovkin — Fri, 20 Feb 2009 21:11:54 GMT

hi

Make sure the ILO FW is the latest...rev 1.70, also check PMC, Check this out:

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c01668472&jumpid=reg_R1002_USEN