Blade server qlogic HBA

kholikt — Sat, 27 Jan 2007 23:31:51 GMT

How to change the HBA setting from loop only to fabric connect? This is a qlogic card.

Re: Blade server qlogic HBA

Sameer_Nirmal — Sun, 28 Jan 2007 19:26:59 GMT

You can change the connection option as Point-to-Point Mode (i.e Fabric Mode ) in the Extended Firmware Settings option of Fast!UTIL.

The Fast!UTIL could be accessed using when you boot the server.

Refer the Qlogic Card User Guide for details.
For qla2300, the guide is at

http://www.ncsa.uiuc.edu/~aloftus/FibreChannel/Qlogic/qla2300_userguide.pdf

Please refer your profile at
http://forums1.itrc.hp.com/service/forums/publicProfile.do?userId=CA610806&forumId=1

which says "I have assigned points to 315 of 974 responses to my questions."

This is not good. Take some time to assign points to the replies of your questions depending on how there were helpful to you to resolve the problems.You would also get fast and more replies if you keep up with assigning points.

Re: Blade server qlogic HBA

Jeff Allen_5 — Thu, 08 Feb 2007 11:04:58 GMT

Which blade server? If this is a pClass 30p or 35p you cannot change it.

topic Blade server qlogic HBA in BladeSystem - General

Blade server qlogic HBA

Re: Blade server qlogic HBA

Re: Blade server qlogic HBA