topic Re: problem with BL860 Server in BladeSystem - General

problem with BL860 Server

Waelkhalil_1 — Sat, 30 May 2009 22:43:18 GMT

Hi ALL

i have a HP C7000 with 2 BL860 Integrity servers attached to each one a Blade Storage, They have HP-UX 11.31 ,They was working fine till i updated the C7000 Enclosure FirmWare to the least Firmware (2.50), After this one of the BL860 unix servers freezes after a while ( i can not ping or connect to it) i must use the ILO to make power cycle to it...it works fine for a while and after that freezes again...

i saw the attached 2 errors repeated in the System Event log of the ILO of the server it is like:
(PCI parity error detected)

and after that the System Event Health changed to Degraded in the HP BladeSystem Onboard Administrator of the Enclouser, until I make another Power Cycle to the server...

Current iLO Firmware Revision:T.03.10 of the Server...

Re: problem with BL860 Server

Patrick Terlisten — Sun, 31 May 2009 08:30:35 GMT

Hello,

please change the device bay or try to re-seat the blade. Are there any mezzanine-cards on the failing blade?

Best regards,
Patrick

Re: problem with BL860 Server

Waelkhalil_1 — Sun, 31 May 2009 08:47:00 GMT

Thanks for Reply...

i try to remove it and return it again , but also it's hangs after awhile ...

there is no mezzanine-cards in these server...

Re: problem with BL860 Server

Waelkhalil_1 — Sun, 31 May 2009 10:34:09 GMT

Sorry it have the following card
HP ISVB Pass-Through Mezzanine for HP BladeSystem