https://community.hpe.com/t5/bladesystem-general/c7000-remote-syslog-stops-working-after-failover/m-p/4538304#M8256 I've just setup a remote syslog server using RHEL5 and Rsyslog and now I want to enable to remote syslog feature on the c7000. After enabling it on the active node, it works fine. Then I switch over to the standby node, apply remote syslog settings there and it also works. But when I switch back to the original one it won't work, I don't get any messages. Even the test message from the web interface doesn't work, only after pressing Apply it starts working again.<BR /><BR />C7000, tried with 2.52 and flashed both to 2.60 to see if that would resolve the problem.<BR /><BR />Any idea? Mon, 23 Nov 2009 11:58:15 GMT sebwise 2009-11-23T11:58:15Z https://community.hpe.com/t5/bladesystem-general/c7000-remote-syslog-stops-working-after-failover/m-p/4538304#M8256 I've just setup a remote syslog server using RHEL5 and Rsyslog and now I want to enable to remote syslog feature on the c7000. After enabling it on the active node, it works fine. Then I switch over to the standby node, apply remote syslog settings there and it also works. But when I switch back to the original one it won't work, I don't get any messages. Even the test message from the web interface doesn't work, only after pressing Apply it starts working again.<BR /><BR />C7000, tried with 2.52 and flashed both to 2.60 to see if that would resolve the problem.<BR /><BR />Any idea? Mon, 23 Nov 2009 11:58:15 GMT https://community.hpe.com/t5/bladesystem-general/c7000-remote-syslog-stops-working-after-failover/m-p/4538304#M8256 sebwise 2009-11-23T11:58:15Z