Move vc modules in c7000 enclosure

gdesmo — Fri, 22 Jan 2010 18:04:31 GMT

I have 2 flex 10 enet modules in bay 1 and 2. And 2 1/10 enet modules in bay 5 and 6. I need to swap them so a bl680c with 10g e mezzanine can use the flex 10 vc module.

I tried backing up the vc config and moving the vc modules but that did not work.

How can I accomplish this? Hopefully I don't have to reconfigure the enclosure from scratch.

Thanks

Re: Move vc modules in c7000 enclosure

The Brit — Fri, 22 Jan 2010 19:58:09 GMT

I'm not sure that this is a simple task.

I believe you can do the opposite, i.e. replace a 1/10G with a Flex10, by inporting the configuration.

However, I would expect problems because the 1/10G hass less memory than the Flex10.

I am curious: What error messages did you get (if any) when you tried to import the configuration? (I assume that this is where it failed).

What procedure exactly, did you use.

vis;
1) shutdown all the blades.
2) removed the VC modules.
3) delete them from the domain.
4) ....

etc. etc.

Dave

topic Re: Move vc modules in c7000 enclosure in BladeSystem - General

Move vc modules in c7000 enclosure

Re: Move vc modules in c7000 enclosure