https://community.hpe.com/t5/bladesystem-general/c-7000-help/m-p/4582786#M9232 Is the PMC firmware at 3.4?<BR />If not you have to get them upgraded.<BR /><BR />any version but 3.4 or 0.5 (Old blades), will give you a warning.<BR /><BR />BR<BR />/jag Fri, 12 Feb 2010 11:05:14 GMT gregersenj 2010-02-12T11:05:14Z https://community.hpe.com/t5/bladesystem-general/c-7000-help/m-p/4582785#M9231 My customer upgraded there firmware to 2.60 and upon the reboot they get a degraded state with 3 blades (windows blades) 3 of the other blades are fine there esx blades. The fiber mezz cards aren't seen by the oa. the os does see the cards. The ilo firmware is up to date and I had him reflash both the oa and the ilo but no luck even a reboot fixed nothing. has anyone seen this before? Fri, 12 Feb 2010 01:23:40 GMT https://community.hpe.com/t5/bladesystem-general/c-7000-help/m-p/4582785#M9231 Dave Chaisson 2010-02-12T01:23:40Z https://community.hpe.com/t5/bladesystem-general/c-7000-help/m-p/4582786#M9232 Is the PMC firmware at 3.4?<BR />If not you have to get them upgraded.<BR /><BR />any version but 3.4 or 0.5 (Old blades), will give you a warning.<BR /><BR />BR<BR />/jag Fri, 12 Feb 2010 11:05:14 GMT https://community.hpe.com/t5/bladesystem-general/c-7000-help/m-p/4582786#M9232 gregersenj 2010-02-12T11:05:14Z https://community.hpe.com/t5/bladesystem-general/c-7000-help/m-p/4582787#M9233 Thanks I will try that tuesday. Sun, 14 Feb 2010 14:23:42 GMT https://community.hpe.com/t5/bladesystem-general/c-7000-help/m-p/4582787#M9233 Dave Chaisson 2010-02-14T14:23:42Z