topic Re: cisco configuration with IMC in IMC

cisco configuration with IMC

doobie3 — Mon, 03 Feb 2014 12:28:34 GMT

Hi you all.

I have IMC 7.0 and most of my switches are cisco 2960.

im able to backup and monitor all of my switches,

but i didnt understood how to configure a cisco switch via the IMC.

for example :

i need to add that line to all of my ciscos :

"logging 1.1.1.1"

can any one give me the exact commands and Response Prompt that i should add to the configuration templates on the IMC ?

LindsayHill — Tue, 04 Feb 2014 02:32:57 GMT

I wouldn't worry too much about response prompts, etc.

You can just do:

conf t

logging 1.1.1.1

exit

And then select the option to save the config.

Response prompts are useful if you need to check specific output, but for a one-line change I wouldn't be too worried about it.

If you've got SNMP read-write access, you could just deploy as a segment, in which case you only need "logging 1.1.1.1"

udaychalla — Wed, 04 Nov 2015 11:51:43 GMT

can you upload the document to cofigure cisco devices to integrate with IMC v7.0

LindsayHill — Tue, 10 Nov 2015 00:17:44 GMT

There's no specific document. Adding new devices is covered in the Admin Guide. The process is the same for both Cisco & HP devices.