https://community.hpe.com/t5/imc/imc-hierarchy-to-remote-site/m-p/7123237#M6283 <P><SPAN>Hello, how it is managed on PRTG and Nagios I have to set up hierarchies in remote offices where the router must correspond to the main node, in case of fault (not response icmp) of the router the switches behind must go into pause and IMC status must send the notification only for the fault of the main node (router)</SPAN></P> Mon, 01 Mar 2021 11:37:25 GMT GIAQUINTO 2021-03-01T11:37:25Z https://community.hpe.com/t5/imc/imc-hierarchy-to-remote-site/m-p/7123237#M6283 <P><SPAN>Hello, how it is managed on PRTG and Nagios I have to set up hierarchies in remote offices where the router must correspond to the main node, in case of fault (not response icmp) of the router the switches behind must go into pause and IMC status must send the notification only for the fault of the main node (router)</SPAN></P> Mon, 01 Mar 2021 11:37:25 GMT https://community.hpe.com/t5/imc/imc-hierarchy-to-remote-site/m-p/7123237#M6283 GIAQUINTO 2021-03-01T11:37:25Z https://community.hpe.com/t5/imc/imc-hierarchy-to-remote-site/m-p/7123992#M6289 <P>Hi,</P><P>Please check pg.no. 735 for iMC hierarchy alarm configuration. Hope this is that you're looking for.</P><P><A href="https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&amp;docId=c05367532" target="_blank">https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&amp;docId=c05367532</A></P><P>-N</P> Thu, 04 Mar 2021 22:25:33 GMT https://community.hpe.com/t5/imc/imc-hierarchy-to-remote-site/m-p/7123992#M6289 Nitish_N 2021-03-04T22:25:33Z