topic Re: HP Comware Lab L2VPN Support in Network Simulator

HP Comware Lab L2VPN Support

Pete W — Mon, 08 Jun 2015 20:06:46 GMT

Any idea whether the new HP Comware Lab (7.1.59) supports L2VPN?

I'm asking as I'm pretty sure that the previous version didn't.

Regards,

Peter

Re: HP Comware Lab L2VPN Support

IngoH — Wed, 10 Jun 2015 14:18:43 GMT

Hello Peter,

7.1.59 does not. You can configure it, but no traffic seems to go through (e.g. after sending a ping one side shows the partners MAC in ARP table, other side does not, seems like unidirectional traffic?).

Same for VPLS.

Best regards,

Ingo

Re: HP Comware Lab L2VPN Support

IngoH — Thu, 16 Mar 2017 12:00:10 GMT

Hello,

To my experience MPLS L2VPN as well as VXLAN/EVPN do not work with bridged-ports in the simulator; can be configured but traffic is not flowing. However they work perfectly using a routed port towards the end-node.

Try for having traffic untagged / access port:
interface GigabitEthernet1/0/1
port link-mode route
xconnect vsi <VSI-Name>

Example adding a tagged VLAN; use a sub interface:
interface GigabitEthernet1/0/1.10
vlan-type dot1q vid 10
xconnect vsi <VSI-Name>

Best use a router manual for reference on the setup, i.e. VSR1000 manuals.

Regards,
Ingo