topic Re: about link aggregation in Network Simulator

about link aggregation

rodtor — Fri, 25 Jun 2021 11:22:56 GMT

Hello, I have a question about link-aggregation. I am using a translator because I am not good at English.

interface GE0/0/0

port link-mode

port link-aggregation group 1

interface GE0/0/1

port link-mode

port link-aggregation group 1

quit

interface route-aggragtion 1

ip address <ip address>

quit

I wonder if the ports in groups can be active or standby when I set them up like this.

And I wonder how many link aggregation groups are possible.

Thank you : )

감사합니다.

akg7 — Fri, 25 Jun 2021 12:56:39 GMT

Hello,

Number of groups creaton depends on devices. One interface can be a member of one group only.

Which device you are using, please share name and product number 'JXXXXX'?

It seem you are creating route aggregation.

You can check the status by using below commands:

For Route Aggregation: Layer 3

display link-aggregation verbose Route-Aggregation

For Bridge Aggregation: Layer 2

display link-aggregation verbose Bridge-Aggregation

Thanks!

rodtor — Fri, 25 Jun 2021 18:09:12 GMT

Oh, I'm sorry. The equipment I'm using is the hp 6616 router.

rodtor — Sat, 26 Jun 2021 09:00:06 GMT

I also wonder how many ports you can set up in a group.

akg7 — Sat, 26 Jun 2021 10:13:02 GMT

Hello,

Maximum 8 interfaces in a group for aggregation.

Thanks!

akg7 — Sat, 26 Jun 2021 11:17:21 GMT

Hello,

Link aggregation group number can be taken in between <1-1032>.

Thanks!