Interface down reset

Stefano_Colombo — Wed, 11 Dec 2024 03:45:29 GMT

We have disconnected a FC interface, which is no longer needed, from controller A on the NIMBLE and deleted an initiator that referenced it.

However the nimble now reports that port as faulty and prevent it from upgrading.

What should we check to mark that interface as healthy since nothing is attached ?

Re: Interface down reset

buzzsubash — Wed, 11 Dec 2024 01:15:55 GMT

Hello,

An interface which is part of active configuration will be considered towards the health status while running the udpate.

As you no longer need the port, You may remove it from the active configuration by following below steps

Administration>Network>Configure Active Settings>Save as draft
Now, you will be redirected to the draft configuration page.
CLick in FC Interfaces tab, click edit button on top
Select the interface and hit the unconfigure button
Once done, save the configuration.
Now, select the draft configuration from Administration>Network page and hit "Make Active" button.

topic Interface down reset in HPE Nimble Storage Solution Specialists

Interface down reset

Re: Interface down reset