topic Re: VCM migration to OneView issue in HPE OneView

VCM migration to OneView issue

PetervdnBosch — Wed, 04 Mar 2015 11:02:01 GMT

Hi!

I am migrating 4 enclosures into HP OneView 1.2. I did not managed to import the second enclosure into the earlier created Enclosure group. Is it possible to add the 4 enclosures into 1 enclosure group after completing the import?

Hope to hear from you soon!

Re: VCM migration to OneView issue

ChrisLynch — Wed, 04 Mar 2015 21:15:04 GMT

As long as all enclosures contain the same interconnect layout, and uplink port configuration, you can re-use the same Enclosure Group that was created by the first VCM Migration operation.

Re: VCM migration to OneView issue

PetervdnBosch — Wed, 04 Mar 2015 22:51:15 GMT

If i understand correctly...

After the first enclosure was migrated there was a Enclosure group

If the second enclosure was configured identical to the firts i could have add this enclosure to the Enclosure group.

En same for the last 2.

That did not happened... i now have 3 enclosure groups (1 migration to go) just because there were some typos...

Is there a possibilty to consolidate all 4 Enclosure groups to one?

Grtz Peter

Re: VCM migration to OneView issue

ChrisLynch — Wed, 04 Mar 2015 23:18:20 GMT

Unfortunately, not without removing the enclosure and then re-adding, which means downtime again.

Re: VCM migration to OneView issue

PetervdnBosch — Thu, 05 Mar 2015 08:42:20 GMT

Thanks Chris!

Hope the community noticed the impact of a small typo during import!

SVR instead of SRV..