topic Re: ONEWVIEW network Setup in HPE OneView

ONEWVIEW network Setup

Mrfall — Mon, 23 Aug 2021 13:15:44 GMT

Hey Folks!

This is the first time to work with Oneview.

I need to create new Vlan on C7500 when I create the VLAN on One View is it Auomatically created on the Switch and uplinks for the Switch or I have to login to the Switch and do it Manually?

Also how can i know the Switch IP connected to the Enclosure.

Thanks

Re: ONEWVIEW network Setup

AmRa — Wed, 18 Aug 2021 08:24:51 GMT

Will you please provide the complete model details (part number) of C7500.

If its with reference to HPE BladeSystem c7000 Enclosure switches (non-virtual connect modules), these switches are managed directly by login to switch console.

However in case of virtual connect modules, first you have to create VLAN in upstream switch and later create VLAN in OneView.

Re: ONEWVIEW network Setup

ChrisLynch — Thu, 19 Aug 2021 21:44:34 GMT

Creating a VLAN within OneView does not typically also create one on the upstream switch side. Depending on your CS700 configuration, you may have to manually configure the switch. That said, there is a Solution Installation Guide document that the CS700 installer should have left you with. It contains all the device addresses and default credentials. If you are unable to locate that, you could look at the Interconnect uplink ports for the LLDP neighbor information. It will show what the device's management IP address is.

Re: ONEWVIEW network Setup

Mrfall — Thu, 19 Aug 2021 21:47:26 GMT

It realy helpful. Actually this is what i was looking for. How I can use LLDP to figure out the neighbor switches. Can you please guide me how i perform this action

Re: ONEWVIEW network Setup

ChrisLynch — Thu, 19 Aug 2021 23:10:42 GMT

You navigate to Interconnects, select the interconnect you want from the inventory, go to the Uplink Ports sub-view, expand one of the uplink ports configured to the Uplink Set, then Remote Connection. This is documented in our online help here.