problem with controller connection

OF2920 — Fri, 04 Dec 2015 13:37:28 GMT

Hi all

Problem: can*t connect to the remote controller!

to do: I try to create the simple topology with 3 VLANs. first - normal switch routing. second - OpenFlow + VoIP. third - controller. My switch 2920-24G. Firmware - 15.14.0012. How can I make conections beetween vlans and what about ip`s? Should I use gateways? It`s my first switch =)

HP-2920-24G(config)# show running-config

Running configuration:

; J9726A Configuration Editor; Created on release #WB.15.14.0012
; Ver #06:0c.18.f3.ff.35.0d:26

hostname "HP-2920-24G"
module 1 type j9726a
snmp-server community "public" unrestricted
openflow
controller-id 1 ip 10.22.1.12 port 6653 controller-interface vlan 3
instance "test"
listen-port 6653
member vlan 2
controller-id 1
version 1.3
enable
exit
enable
exit
oobm
ip address dhcp-bootp
exit
vlan 1
name "DEFAULT_VLAN"
no untagged 17-24
untagged 1-16,A1-A2,B1-B2
ip address dhcp-bootp
exit
vlan 2
name "hosts"
untagged 17-23
no ip address
voice
exit
vlan 3
name "VLAN3"
untagged 24
no ip address
exit

HP-2920-24G(config)# show openflow instance test

Configured OF Version : 1.3
Negotiated OF Version : NA
Instance Name : test
Admin. Status : Enabled
Member List : VLAN 2
Listen Port : 6653
Oper. Status : Up
Oper. Status Reason : NA
Datapath ID : 0002480fcf0a8680
Mode : Active
Flow Location : Hardware and Software
No. of Hw Flows : 0
No. of Sw Flows : 0
Hw. Rate Limit : 0 kbps
Sw. Rate Limit : 100 pps
Conn. Interrupt Mode : Fail-Secure
Maximum Backoff Interval : 60 seconds
Probe Interval : 10 seconds
Hw. Table Miss Count : NA
No. of Sw Flow Tables : 1
Egress Only Ports : None
Table Model : NA

Controller Id Connection Status Connection State Secure Role
------------- ----------------- ---------------- ------ ------
1 Disconnected Connecting No Equal

Can anybody detect my problem, or give advise what to do?

Thank you for atention.

topic problem with controller connection in Software Defined Networking

problem with controller connection