topic Re: Simplivity dsv- commands in HPE SimpliVity

Simplivity dsv- commands

SGMacaulay — Thu, 09 May 2019 13:32:31 GMT

During a support session this week the tech used the command dsv-balance-show. Showed a lot of interesting information and after adding a new node this week I wanted to run this command again to see how things are balancing out. After SSHing to the OVC I cannot figure out were that commands lives, I get command not found. I think the tech changed directories but I did not note that. Can some one tell me where to find this command?

Re: Simplivity dsv- commands

DeclanOR — Thu, 09 May 2019 13:36:43 GMT

Hi @SGMacaulay

To run dsv commands, simply log onto the OVC with your vCenter credentials, and at the prompt type

sudo <dsv command>

In your case : sudo dsv-balance-show

Thanks,

DeclanOR

Re: Simplivity dsv- commands

Stefano_Colombo — Tue, 01 Sep 2020 10:21:35 GMT

to avoid to use sudo on each command the source command can be used, I cannot remember the complete path to use with the source command

sudo su

source ..

Re: Simplivity dsv- commands

Stefano_Colombo — Tue, 01 Sep 2020 12:32:34 GMT

the source command is

source /var/tmp/build/bin/appsetup