topic Re: How to remove aaa commands from an HP Procurve 3448cl in HPE Aruba Networking & ProVision-based

How to remove aaa commands from an HP Procurve 3448cl

sdewndr — Sat, 12 Mar 2011 22:47:44 GMT

I'm trying to remove some misconfigured aaa commands from an HP 3448cl switch. Example:

aaa authentication telnet login tacacs local
aaa authentication ssh login tacacs local

to remove, I've tried placing a "no" in front of them and it just fails. Any ideas?

Re: How to remove aaa commands from an HP Procurve 3448cl

Jeff Carrell — Mon, 14 Mar 2011 07:13:55 GMT

You can't remove these commands, you have to basically reset them back to original or different:

aaa authentication telnet login local
aaa authentication ssh login local

would reset them back to original state.

Below is the basics of the overall command 'aaa authentication':

aaa authentication <access method [console, telnet, ssh, web]> <login or enable> <primary auth [local, radius, tacacs]> <sec auth [none, local, radius, tacacs]>

hth...Jeff

Re: How to remove aaa commands from an HP Procurve 3448cl

RayMK — Wed, 04 Sep 2013 07:24:01 GMT

wish i knew this.

i was testing radius and couldnt remove the commands

reloaded the switch to original config in the end.

will remember that that you cannot remove them but reset them in future

lesson learnt

Re: How to remove aaa commands from an HP Procurve 3448cl

boziah — Wed, 18 Sep 2013 13:02:40 GMT

I was able to remove entries aaa authentication telnet login local
I typed the command aaa authentication telnet login local and it was removed